Why does the conveyor belt slip

Conveyor mesh belt types: mesh belt, conveyor belt, stainless steel mesh belt, mesh belt, food mesh belt, mesh belt oven, high temperature mesh belt, stainless steel metal mesh belt, stainless steel conveyor mesh belt, mesh belt factory, basement mesh belt, etc.






There are many reasons why the conveyor belt slips during operation. The common causes and solutions are as follows:

1. The initial tension is too small. Insufficient tension of the conveyor belt leaving the drum can cause the conveyor belt to slip. This situation usually occurs at startup. The solution is to adjust the tensioning device to increase the initial tension.

2. The friction between the driving roller and the conveyor is insufficient, causing slipping. The main reason for rejection is water or humid environment on the conveyor belt. The solution is to add a little rosin powder to the drum. But be careful not to throw it with your hands, use a blowing device to blow air to avoid personal accidents.

3. The rear roller bearing is damaged and does not rotate, or the upper and lower roller bearings are damaged and do not rotate too much. The cause of the damage is that the tail floats too much, and the damaged or inflexible parts are not repaired and replaced in time, which increases the resistance and causes skidding.

4. Too fast starting speed can also cause slippage. You can start slowly at this time. If the squirrel cage is used, it can be started by two jogs and can effectively overcome the slipping phenomenon.

5. The load on the mesh belt of the conveyor is too large, and it will slip if it exceeds the electrical capacity. The advantage of sliding at this time is that it can protect the electricity, otherwise it will burn out after a long time. But for operation, it is a slip accident. To overcome the slip of the conveyor belt, the cause of the slip must be found before effective measures can be taken.