The reason for the slippage of the conveyor belt and the introduction of adjustment methods

Conveyor mesh belt types: mesh belt, conveyor belt, stainless steel mesh belt, mesh belt conveyor, food mesh belt, mesh belt furnace, high temperature mesh belt, stainless steel metal mesh belt, stainless steel conveyor mesh belt factory, mesh belt room, etc. When the conveyor belt is running, the tension of the conveyor belt is not enough when it leaves the drum, so the conveyor belt will slip.





1. This situation usually occurs at startup. The solution is to adjust the tension device to increase the initial tension. 2. The friction between the drive roller and the conveyor belt is insufficient and slips. Many of these factors are the presence of water on the conveyor belt and the humidity of the environment. The solution is to add rosin to the drum. However, please be careful not to throw it in with your hands or blow it in with air supply equipment, which may cause personal accidents. 3. The damage of the tail drum bearing does not rotate or the damage of the upper and lower support roller bearings does not rotate too much. The cause of the damage is that the tail fluctuates too much, the inspection and replacement of the damaged parts and the parts with inflexible rotation are delayed, and the resistance becomes large and slips. 4. It can skid even if the starting speed is too fast. You can start slowly at this point. If you use cage electricity, you can start it after two taps, which can effectively overcome the slipping phenomenon. 5. The load of the conveyor belt is too large, even if it exceeds the electric capacity, it will slide. At this time, the side that is conducive to sliding plays a role in protecting electricity. If it takes time, the electricity will burn. However, it is a slip accident for operation. To overcome the sliding phenomenon of the conveyor belt, the cause of the sliding must be found first, and then effective solutions can be taken.