How do you extend the service life of wire mesh conveyor belts?

When your conveyor belt runs out, this can be a big deal for the business. In fact, it will cause production to stop. This is why it is very important for you to do your best to extend the service life of the wire mesh conveyor belt.

Wire mesh conveyor
How can I make the most of my wire mesh conveyor belt?
The first thing you need to do is to make sure that the conveyor belt is installed correctly. The edge of the single or double loop of the waistband should be bent back, away from its way of travel. The smooth side should always face up. If your belt is not installed correctly, it may cause an accident and delay the production time due to damage to the conveyor belt.

You also need to pay attention to the contact between the support bar and the z-bend. If the joint on the underside of the conveyor belt rubs or has any contact with the support bar, this may cause additional wear and fatigue failure.

The drive seat teeth of the conveyor belt need to be perfectly aligned. In this way, they will all pull together smoothly. If they cannot be pulled smoothly, it may cause some strands to withstand stress overload.

If the transmission or reverse bending ratio is too small, the z-bending stress will increase. This will cause the z-bend joint to eventually form its own groove in the transfer support.

What kind of routine maintenance should I perform on my wire mesh conveyor belt?
One thing you want to focus on is the drive components. If they are worn or damaged, be sure to replace them. Worn drive sprockets or idler sprockets can cause your belt to jump from side to side or drift to the other side. This will cause premature wear of the conveyor belt.

You also need to check for any improper gaps between the z-bend and the drive sprocket. z The bend should not come into contact with any other components. You should maintain a gap of at least 3/16" to 1/4".

Make sure that the tension on the conveyor belt is never too great. Too much tension will cause the wires to pull apart and cause the belt to fail.

in conclusion
By properly installing your wire mesh conveyor belts and routinely inspecting them, you can extend their lifespan. This is very important when your business depends on good productivity. If you encounter a malfunction on this device, it may cost you time and money, which is something no business wants to experience.